Maytag MED6230HW Manual De Instrucciones página 11

2.
Connect neutral ground wire
and neutral wire
C
Connect neutral ground wire (E) and neutral wire (white) (C) of
power supply cord under center terminal block screw (B).
Tighten screw.
3.
Connect ground wire
F
Connect ground wire (F) (green or bare) of power supply cord to
external ground conductor screw (A). Tighten screw.
4.
Connect remaining wires
Connect remaining wires to outer terminal block screws. Tighten
screws. Finally, reinsert tab of terminal block cover into slot of
dryer rear panel. Secure cover with hold-down screw. Now, go to
"Venting Requirements."
3-wire Power Supply Cord Connection
Use where local codes permit connecting cabinet-ground
conductor to neutral wire.
E
B
3-wire receptacle
(NEMA type 10-30R)
Spade terminals with
upturned ends
1.
Remove center screw
A
Remove center terminal block screw (B).
2.
Connect neutral wire
Connect neutral wire (white or center) (C) of power supply cord to
center terminal block screw (B). Tighten screw.
3-prong plug
Ring terminals
B
C
B
11