Timer Function - American Hometec AHQ-TB32 Manual De Instalación Y Funcionamiento

Timer function

The timer function allows the setting of how long a hot water draw will run
before the system stops heating the water, water will get cold.
Timer Setting
(1) Press the TIMER button and remove the finger, the indicator
will start flashing.
(2) Adjust the time by the UP or DOWN button, it will increase or decrease 1
minute one time. Holding the UP or DOWN button for 2 seconds, it will
increase or decrease 10 minutes one time.
(3) Remove the finger for 10 seconds or press the TIMER button again, the
set time will be automatically confirmed.
(4) The water heater will stop to heat the water when they finish the
minutes you set.
Timer Cancel
Holding the TIMER button for 5 seconds, the timer will be cancelled. Then
the indicator
5. Set the desired water temperature by pressing power level "UP" or
"DOWN" button on the control panel. Turn the hot water faucet on all the
way let initial cold water in the pipe run out, you will get the hot water close
to the temperature you set. How close to the temperature you set depends
on how close you have installed the unit to the fixture. Regardless of varing
incoming water temperature, this unit will supply hot water at a constant
temperature that is close to the temperarture you set (or factory default
setting at 110°F if you have not changed the default temperature setting),
provided the hot eater application is within the unit's capacity. The power
setting as follows:
Power setting selection (Fig 4)
Power setting
indicate will show the using time.
Power Adjustment Range AHQ-TB32
Setting 1
31 kW
13
Setting 2
25 kW