Functional Description; Technical Specifications - Skil 2211 Manual De Instrucciones

replaced immediately.
• Do not disassemble charger or battery 8.
• Do not attempt to recharge non-rechargeable
batteries with the charger.
Explanation of symbols on charger/battery
Figure 2 Read the instruction manual before use.
Figure 3 Only use the charger indoors.
Figure 4 Double insulation (no earth wire
required).
Figure 5 Automatic shut-off when charger gets too
hot (thermic fuse blows and charger becomes
useless).
Figure 6 Incorrect polarity of the charger
connection could cause a hazard (only charge the
battery with the charger supplied).
Figure 7 Do not dispose of the charger together
with household waste material.
Figure 8 Do not dispose of the battery together
with.household waste material.
WHEN CONNECTING NEW 3-PIN PLUG (U.K.
ONLY):
• Do not connect the blue (= neutral) or brown (=
live) wire in the cord of the charger to the earth
terminal of the plug.

Technical specifications

Cordless drill and driver
Model
Type nº
Rated voltage
Change time
No-load speed
Torque Max.
Chuck claming range
Maximum drilling:
Steel
Wood
Screw diameter, Max
Weight according to EPTA 01/2003
NOISE/VIBRATION INFORMATION
Measured values determined according to EN
60745.
Typically the A-weighted sound pressure level of
the product is <70 dB(A). Uncertainty K=3 dB. The
noise level when working can exceed 80 dB(A).
Wear hearing protection!
Vibration total values (triax vector sum)
determined according to EN 60745:
Drilling into metal: Vibration emission value
2
ah=2.3 m/s , Uncertainty K =1.5 m/s
• If for any reason the old plug is cut off the cord of
the charger, it must be disposed of safely and not
left unattended.

Functional Description

INTRODUCTION
This tool is intended for drilling in wood, metal,
ceramic and plastic; tools with electronic speed
control and left/ right rotation are also suitable for
screw driving and thread cutting.
TOOL ELEMENTS (Figure 2)
A Switch for on/off and speed control
B Switch for changing direction of rotation
C Keyless chuck
D Ring for torque control
E Indicator of selected direction of rotation
F Indicator of selected clutch setting
G Magnetic bit holder
H Screwbit identification and storage
J Ventilation slots
K Charger
L Red charging light
2211
012 221 1..
[V] 9,6
[h] 3
[/min] 0-550
[Nm] 7
[mm] 13
[mm] 6
[mm] 18
[mm] 5
[kg] 1,5
The vibration emission level given in this
information sheet has been measured in
accordance with a standardized test given in EN
60745 and may be used to compare one tool with
another. It may be used for a preliminary
assessment of exposure.
The declared vibration emission level represents
the main applications of the tool. However if the
tool is used for different applications, with different
accessories or poorly maintained, the vibration
emission may differ. This may significantly
2
.
21
2311 2411
F 012 231 1.. F 012 241 1..
12 14,4
3 3
0-550 0-550
9 11
13 13
6 6
20 25
5 5
1,5 1,6