Care And Maintenance - Marshall MF-110-XMC Manual Del Propietário

WARNING
DANGER
CAUTION
WARNING
DANGER
CAUTION
64
• Change the position of lower hinge (5) to the opposite side of the appliance, locate and support the door onto the
lower hinge (5), replace screws (6) and adjustable foot (4 & 7), align door and replace the upper hinge (3) and replace
screws (2).
• Fit the hinge cover (1).

Care and Maintenance

Marshall Fridge Exterior Care
Use a dry cloth to dust off fret cloth fabric, very gently. Use a damp cloth for metal surfaces.
Defrosting Your Unit
• Defrosting of your refrigerator should take place whenever ice build-up inside the freezer compartment reaches
/ inch of thickness. Set the thermostat dial to "0" position.
1
4
• To speed up the defrosting process, remove all frozen foods from the freezer section. Leaving the door partially ajar
WARNING
for a short period of time will also speed up the process.
• You must remember to close the refrigerator door before the defrost cycle terminates and normal operating
conditions resume automatically. The drip tray should be in position directly below the freezer compartment to catch
condensed water during defrosting.
DANGER
• Never use sharp or pointed instruments to remove ice from the freezer compartment. The freezer compartment
contains refrigerated gas lines and if accidentally punched/pierced, will render the refrigerator inoperable and void the
manufacturer's warranty.
CAUTION
Failure to unplug the unit could result in electrical shock or personal injury.
Cleaning Your Unit
Before proceeding with cleaning and maintenance operations, make sure the power line of the unit is disconnected.
• Turn the temperature control to "0", unplug the unit, and remove the food, shelves, and trays.
• Wash the inside surfaces with a warm water and baking soda. The solution should be about 2 tablespoons of baking
soda to a quart of water.
• Wash the shelves and trays with a mild detergent solution.
• The outside of the unit should be cleaned with a soft dry cloth.
• Do not use solvent-based cleaning agents or abrasives on the interior. These cleaners may damage or discolor
the interior.
9