Tabla de contenido
Publicidad
Installation Instructions
Before Using Your Unit
Remove the exterior and interior packaging.
Before connecting the unit to the power source, let it stand upright for approximately 2 hours. This will reduce the
possibility of a malfunction in the cooling system from handling during transportation.
Installing Your Unit
This appliance is designed to be free standing only, and should not be recessed or built-in.
Location
Remove exterior and interior packaging; wipe the outside thoroughly with a soft dry cloth and the inside with a damp,
lukewarm cloth. Avoid placing the unit in a narrow recess or near any heat source, direct sunlight, or moisture. Let air
circulate freely around the unit. Keep the rear of the refrigerator 5 inches away from the wall.
Follow Below Steps Carefully:
1) Select a place with a level floor.
2) Allow 5 inches of space between the back of the refrigerator and any adjacent wall.
3) Avoid direct sun and heat. Direct sunlight may affect the coating. Heat sources nearby will cause higher electricity
consumption.
4) Avoid damp places. Too much moisture in the air will cause frost to form very quickly on the evaporator, and your
refrigerator will have to be defrosted more frequently.
5) Plug the unit into an exclusive, properly installed-grounded wall outlet. Do not under any circumstances cut or
remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be
directed to a certified electrician or an authorized call center. For voltage and outlet style please refer to our website
www.marshallfridge.com.
6) After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before placing food in the
refrigerator and freezer compartments.
6
67
Publicidad
Capítulos
Tabla de contenido
