To Set/Recall the radio presets
• Press the On/off button to turn the unit on.
• Press the FUNCTION button to select the Radio Mode.
• Use the Tune UP or Tune DOWN button to select the desired FM station.
• Press the clock set/memory button; "P01"will blink in the display.
• Press the clock set/memory button again to set the preset.
• Repeat steps 2 through 4 to set more presets.
• The unit can preset 20 stations totally FM.
• When "P01-P20" is blinking, press Tune UP or Tune DOWN to select the Preset
number.
• When recalling preset stations, press Mem – up to select the Preset number.
Sleep Operation
• When listening to radio or iPhone® / iPod® , press sleep button to enter sleep
mode. You can just adjust the sleep timer from 90 mins to 10 mins by pressing
the sleep button. The unit will automatically turn off after the selected time.
• Press On/Off button to cancel sleep function.
AUX in
• The AUX in jack can be used to playback alternate audio signal sources on the
unit speakers.
• This AUX in jack requires a 3.5mm audio cable for input signal.
Note : This unit does not provide a recording signal from AUX in to the iPhone® / iPod®
.It' s purpose is to allow other types of audio devices to playback on the unit speaker.
Note : The 3.5mm audio cable is not included.
SNOOZE INFRARED SENSOR FUNCTION
In alarm On mode, use the infrared sensor to turn snooze
function On
Hand on top of sensor within 1 second snooze off for 9
minutes.
WARNING
1.
No naked flame sources, such as lighted candles, should be placed on the
apparatus.
2.
Do not place the product in closed bookcases or racks without proper
ventilation.
3.
The mains plug will have to be easily reachable because it's the only way to
completely turn of the CL-1461.
4.
The ventilation should not be impeded by covering the ventilation openings
with items, such as newspapers, table-cloths, curtains, etc.
5.
It shall not be exposed to dripping or splashing and that no objects filled with
liquids, such as vases, shall be placed on the apparatus.
6.
Do not connect FM antenna to outside antenna.
7.
The unit should not be exposed to direct sunlight, very high or low
temperature, moisture, vibrations or placed in dusty environment.
8.
Do not use abrasive, benzene, thinner or other solvents to clean the surface
of the unit. To clean, wipe it with mild non-abrasive detergent solution and
clean soft cloth.
9.
Never attempt to insert wires, pins or other such objects into the vents or
opening of the unit.
10. Disconnect device warning: Main plug is used as the connection; so it should
always remain ready operate.
11. Batteries shall not be exposed to excessive heat such as sunshine, fire or the
like.
CAUTION
• Danger of explosion if battery is incorrectly replaced
• Replace only with the same or equivalent type
EN
Instruction Manual