Power On And Off; Aux Input; Usb Input - EDIFIER Sound To Go Plus Manual De Usuario

Connectivity
Indicator light
(Red: Charging / Blue: In use, powered on)
Vol.+: Volume increase
Side view (right)
Vol.-: Volume decrease
Side view (left)
3
English

Power on and off

Power On: Press & hold "Vol. +" and "Vol. –" at the same time for approximately 3 seconds, the system is now on and
the indicator light is blue.
Power Off: Press & hold "Vol. +" and "Vol. –" at the same time for approximately 3 seconds, the system is now off.

AUX input

1. Connect the Sound To Go Plus to your audio device (mobile device, tablet, PC sound card, MP3, MP4 etc.) with the
3.5mm-3.5mm audio cable.
2. Press "Vol. +/-" to adjust the volume to desired level.

USB input

1. Connect the Sound To Go Plus to your desktop computer or laptop with the USB-mini USB cable.
2. Press "Vol. +/-" to adjust the volume to desired level.
Note: When connect to USB port, the Sound To Go Plus will use the power from the device and start to charge the built in
Lithium Ion battery.
Note:
Audio input priority sequence: AUX > USB input (when AUX and USB input at the same time)
When using the USB streaming connection, do not connect the 3.5mm-3.5mm audio connecting cable to the same
device (eg. Laptop computer). If both cables are connected while in USB streaming mode there will be no audio
output from the device.
Operation guide
4
English