Dmx Connection - HQ-Power VDPLWB Manual Del Usuario

7.9 Receiver Mode
1. Connect the VDPLWB to your fixture using a DMX cable.
2. Press MENU until the display shows <Input Mode>. Conform with
ENTER. Use UP/DOWN to select <WIFI>. Conform with ENTER.
3. Press MENU until the display shows <Channel Mode>. Conform with
ENTER. Use UP/DOWN to select your channel. Conform with ENTER.
Remark:
Make sure not to exceed the distance of 700 m between receiver and
transmitter.
One transmitter can be connected to up to 512 receivers.
a. transmitter

7.10 DMX Connection

 When applicable, connect an XLR cable to the female XLR output of a
controller (not incl.) and the other side to the male XLR input of the
device. Multiple devices can be linked through serial linking. The linking
cable shall be a dual core, screened cable with XLR input and output
connectors.
DMX input
V. 01 – 09/02/2015
VDPLWB
1 GND
2 negative
3 positive
8
b. receiver
DMX output
©Velleman nv