Please note that the projector can also be operated in 16-bit-mode. In the 16-bit-mode, the projector
occupies 7 control channels. The projector can be switched to 16-bit-mode via the Function-DIP-switches.
Controlling:
After having addressed all TMH-150, you may now start operating these via your lighting controller.
Note:
After switching on, the TMH-150 will automatically detect whether DMX 512 data is received or not. If the
data is received, the the display will show "A001" with actually set address and the DMX-LED is lit. If there is
no data received at the DMX-input, the DMX-LED is off.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the TMH-150.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
DMX-protocol
Control channel 1 - Horizontal movement (Pan) (within 360°)
Push slider up in order to move the head horizontally (PAN).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center). The head can be
stopped at any position you wish.
Control channel 2 - Vertical movement (Tilt) (within 250°)
Push slider up in order to move the head vertically (TILT).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center). The head can be
stopped at any position you wish.
Control channel 3 - Colour-wheel
DMX-value
Feature
0-15
Open / white
16-31
Violet
32-47
Blue
48-64
Green
65-81
Yellow
82-97
Red
98-113
Light blue
114
Orange
115-255
Rainbow effect with increasing speed
Control channel 4 - Static gobo-wheel
DMX-value
Feature
0-31
Open
32-63
Gobo 1
64-95
Gobo 2
96-127
Gobo 3
128-159
Gobo 4
160-191
Gobo 5
192-223
Gobo 6
224-255
Gobo 7
Control channel 5 - Shutter, Dimmer
DMX-value
Feature
0-48
Shutter closed
49-122
Dimmer control (shutter open)
123-139
No function (shutter open)
140-240
Strobo effect with increasing speed (max. 13 flashes/second)
241-255
No function (shutter open)
28/58
51786400X51NXS_V_1_0.DOC