Dmx-Protocol; Inserting/Replacing The Battery; Cleaning And Maintenance - EuroLite LED PAR-64 Manual Del Usuario

DMX-protocol

Channel 1 Red
0 - 255 0-100 %
Channel 2 Green
0 - 255 0-100 %
Channel 3 Blue
0 - 255 0-100 %
Channel 4 Dimmer
0 – 255 0-100 %
Channel 5 Flash
0 - 10 No function
11 - 255 0-100 % with increasing speed

Inserting/Replacing the battery

Please refer to the explanations under Operating Determinations.
Open the battery cover on the rear of the remote control and remove it.
If replacing the battery, remove the old battery from the battery compartment.
Leaky or damaged batteries might cause cauterisation when in contact with the skin; therefore, use suitable
protective gloves.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty battery in accordance with the instructions of the manufacturer.
Insert the battery and make sure that the poles are correct.
Replace the battery cover and close it.
If the device will not be used for a longer period of time, remove the battery in order to avoid battery leakage.
In order to have a long battery life, you should only use alcaline batteries.
Batteries are hazardous waste and should not be disposed of with regular domestic waste!
Please take old and used batteries to a collection center near you.

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Danger of explosion when battery is replaced improperly.
BATTERY DISPOSAL NOTICE
Please dispose of old and used batteries properly.
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
Caution!
20/39 51914100_V_1_0.DOC