Mounting The Main Wheels; Standard Tyres; 6-Hole Rim Variant; Mounting The Chassis Frame - Vicon ANDEX 773 Instrucciones De Montaje

EN
S
M 325 Nm
Fig. 3-2
S
M 325 Nm
Fig. 3-2a
U
T
V
Fig. 3-3
10
R 290 Nm
E
3.3

Mounting the main wheels

3.3.1 Standard tyres

Attach the wheels for the main chassis to the axle
stubs. Then bolt the wheel onto the axle stub using
Ø21mm washer (S) and M20 nut (M) and fit the
hub cap on the rim (fig. 3-2). Use the content of
bag D.
Attention!
Observe the torque of the wheel nuts
(325 Nm)!

3.3.2 6-hole rim variant

Mount the two main wheels with the wheel nuts.
Use the content of bag H.
Attention!
Observe the torque of the wheel nuts
(325 Nm)!
3.4

Mounting the chassis frame

Rest the rear chassis frame (T) on a parking
support.
Danger!
The minimum carrying capacity of
the parking support must be at least
1 tonne!
Lower the pre-mounted parking support on the
longitudinal support (E) and bring the longitudinal
support up to the rear chassis frame by means of
a crane.
Connect longitudinal support (E) with chassis
frame (T) using M16 screws (U) (fig. 3-3 ). Use
the content of bag I.
Attention!
Observe the torque of screws (U)!