Velleman CAMCOLVC26N Manual Del Usuario página 11

CAMCOLVC26N
Number
Settings: 1 photo, 2 photos, 3 photos
Select the number of photos to be taken in succession when the camera is
triggered in photo mode. Please also observe the parameter Interval (see
below).
Length of video
Settings: 10 sec, optional 1-60 sec and 3, 5 and 10 min
Specify the duration of a video when the camera is triggered automatically.
The recording period for videos is not limited in test mode.
Interval
Settings: 30 sec, optional from 5 sec to 60 min
Select the shortest period for the camera to wait before it reacts to the
successive triggering of the main sensor after an animal has first been
detected. The camera does not record any images or videos during the
selected intervals. This prevents the memory card from being filled with
unnecessary shots.
Time stamp
Settings: On/Off (only available in photo mode)
Select whether to display the date, time, temperature and moon phase on
each photo.
Timer
Settings: Off/On
Switch on the timer if the camera should only be active within a certain
time. Once activated, the start and end time can be set.
Example: If the start time is set to 18h35 and the end time set to 8h25, the
camera will be operational from 18h35 to 8h25 the following day. The
camera will not be triggered and will not take any photos or videos outside
this period.
Password
Settings: Off/On
When this option is activated, the four-digit password must be entered each
time the camera is switched on in the test mode before the camera can be
used.
The camera will no longer be useable in case of a lost password. Please
contact your nearest dealer.
Serial no.
Settings: Off/On (only available in photo mode)
Activate this option to assign a serial number to the camera.
Use a combination of four digits or letters so you can identify your camera in
a multi-camera set-up.
V. 02 – 26/09/2018 11 ©Velleman nv