Input Channel Section - HQ-Power HQMX10001 Manual Del Usuario


Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.

Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room temperature.

Keep this manual for future reference.
4. Features

mini 4/8-channel analogue mixer with 1 stereo channel

3-band active EQ (high, mid, low)

distortion under 0.0007 % (20 Hz - 20 kHz)

phantom power for studio condenser mics

24-bit DSP processor (99 effects)

ALT 3/4 stereo bus for added versatility

precise 3-colour, 6-band LED level display

MP3 player is compatible with various audio formats
5. Overview
Refer to the illustrations on page 2 of this manual.
5.1

Input Channel Section

MIC INPUTS
1.
Female XLR connector for almost any type of microphone, such as dynamic, ribbon and
condenser microphones.
MONO LINE INPUTS
2.
These ¼" jacks share circuitry with the microphone inputs but do not feature phantom power.
They are suited for balanced or unbalanced sources.
Connection of a balanced source: use a ¼" mono phone plug, wired as follows:
Connection of an unbalanced source: use a ¼" mono phone plug, wired as follows:
GAIN CONTROL
3.
The gain knob adjusts the sensitivity of the microphone inputs. This allows you to adjust the
incoming signals.
The signal remains unmodified when the knob is turned fully CCW and amplified to 60 dB
when the knob is turned fully CW.
AUX SEND
4.
The signal from the auxiliary send is often connected to a stage monitor.
5. FX SEND
The signal from the auxiliary send is often connected to an outboard effects unit (e.g. reverb)
and then returned to the mixer. This allows effects to be added to an audio source or channel.
CHANNEL EQ
6.
All channels have 3-band EQ with high, mid and low filters.
HIGH EQ
The high EQ provides up to 15 dB of boost or cut above 12 kHz and is also flat (no boost or
cut) at the detent.
MID EQ
The mid EQ provides up to 15 dB of boost or cut above 2.5 kHz and is also flat (no boost or
cut) at the detent.
LOW EQ
The low EQ provides up to 15 dB of boost or cut below 80 Hz and is also flat (no boost or cut)
at the detent.
V. 03 – 22/03/2017
HQMX10001/HQMX10002
tip = positive (+ or hot)
ring = negative (- or cold)
sleeve = shield or ground
tip = positive (+ or hot)
sleeve = shield or ground
4 ©Velleman nv