Master Section - HQ-Power HQMX10001 Manual Del Usuario

PAN
7.
This control adjusts the amount of channel signal sent to the left or right output.
OL LED
8.
The overload (OL) LED will burn when the channel's input signal is too high. This should be
avoided as distortion will occur. Lower the amount of gain if the OL LED burns regularly.
MUTE SWITCH
9.
The mute switch cuts the signal from the channel. The signal is sent to the alt outputs (16).
LEVEL
10.
This control allows you to adjust the volume of each channel.
5.2

Master Section

11. TAPE INPUT
These stereo unbalanced RCA inputs allow you to play a tape, CD player or other line-level
source. The input is only enabled when the TAPE switch is engaged.
REC OUTPUT
12.
Stereo outputs for recording onto a tape deck, hard disk recorder or automatic CD burner.
The recording output has the same signal as the main output. The output can also be used as
an extra main output.
TRS CONNECTOR
13.
Balanced output for the mixed stereo channel. Can also be used as an unbalanced output.
Use it to feed a sound processor or the L/R speakers. The signal with balanced use is 6 dB
stronger than the signal with unbalanced use.
LINE IN 3/4 or 7/8
14.
Stereo channel with identical functions as the mono channel. To be used as balanced or
unbalanced input.
MP3 SWITCH
15.
Switches the stereo channel between the line and MP3 input.
ALT L/R OUTPUT
16.
Balanced or unbalanced output. The signal is a mix of all channels where the ALT3-4 switch
has been pressed.
FX SEND/RETURN
17.
These ¼" connectors allow you to send the FX line-level outputs to external effects processors
while disconnecting the internal effects processor.
Send: Connection to an external effects unit.
Return: Connection from an external effects unit.
HEADPHONE OUTPUT
18.
Connection for your stereo headphones with ¼" connector.
AUX SEND
19.
Balanced or unbalanced output for stage monitors, or alternatively, an outboard effects unit.
MP3 SECTION
20.
a. USB port
b. MP3 display
c. MP3 player control
AUX SEND MASTER
21.
Overall level control of AUX SEND output.
FX SEND
22.
Overall volume level control of FX SEND output. Adjust carefully to prevent overloading the
effects processor.
V. 03 – 22/03/2017
HQMX10001/HQMX10002
5 ©Velleman nv