Replacing The Batteries In The Ol1000 Sc1 - CMF OL1000 SC Manual De Instrucciones

Ocultar thumbs Ver también para OL1000 SC:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EN

Replacing the Batteries in the OL1000 SC1

WARNING: Battery operated device (9V alkaline battery), not to use
lithium batteries .
The LCD screen will show the following picture when it is time for
new batteries . This picture will be shown at the start of a treatment
or during a treatment . The device will turn off after this picture is
displayed .
Never change the batteries when the device is running . Wait until the
device stops operating to change the batteries .
For the OL1000 SC1, the picture in Figure 3, below, shows the correct
way to replace the battery . When replacing the battery, you will see the
correct way to put them in on the inside of the battery compartment .
Use ONLY the batteries supplied with the OL1000 SC1 . They are located
in the carrying case .
Note: Be sure to remove plastic from batteries before replacing them.
Figure 3 . OL1000 SC1 – Battery Compartment
9

Publicidad

Tabla de contenido
loading

Tabla de contenido