Impecca IWA-15KSFP Manual De Usuario página 13

WInDoW MoUnTInG (ConTInUeD):
3. Install support brackets(with sill angle
brackets attached) to correct hole in
bottom of cabinet as shown.
4. Tighten all 6 bolts securely.
6 Extend Window Filler Panels
1. Carefully raise window to expose filler panel
locking screws. Loosen screws so filler panels
slide easily.
2. Extend panels to fill window opening completely.
Tighten locking screws on top.
3. Close window behind top angle.
Install Window Lock and
7
Sash Seal
1. Trim sash seal to fit window width. Insert into
space between upper and lower sashes.
1 2 Long Screws
and Locknuts
Window Sash Seal
2. Attach right angle safety lock as shown.
Install Chassis into Cabinet
8
and Install Front to Unit
1. Lift air conditioner and carefully slide into
cabinet leaving 6 inches protruding.
2. DO NOT push on controls or finned coils.
3. Be sure chassis is firmly seated towards rear
of cabinet.
4. Installation of front is the reverse of removal
outlined in Section 1.
11
14
Safety Lock
3 4 (or1 /2 )Long
Hex-head Screws