In-WAll InsTAllATIon (ConTInUeD):
NOTE: If wall thickness is 8-1/2 or more, add
aluminum flashing over bottom of frame opening
to assure no water can enter area between inner
and outer wall.
Aluminum Flashing
Over Bottom Of Frame
3
Prepare and Install Cabinet
1. Slide chassis from cabinet. Refer back to Step
one of Window Mounting.
2. Place cabinet into opening with bottom rail
resting firmly on bottom board of wooden
frame.
3. Position cabinet to achieve proper slope for
water removal. (See Fig.1 below.)
5/16
to 3/8
Level
4. Secure bottom rail to wood frame with two large
wood screws 1 (2.5cm) long using the two holes
in the bottom of the channel resting on frame.
(See Fig.2 following).
Caulkas
Required
Over
8-1/2
3 4 plus trim
/
thickness
See Para 5
Fig.1
Fig.2
Refer to Step 4 of Window Mounting for assembly
of support brackets. A wooden strip nailed to the
outside wall should be used in conjunction with
sill support angle brackets.
5. Screw or nail cabinet wooden frame using
shims if frame is oversized, to eliminate
distortion. Remember to maintain proper
slop as described in Step 3.
6. Install chassis into cabinet by following all
steps in Step 8 of Window Mounting.
13
16
1 Long Wood
Screw
Support
Bracket
Wooden
Strip