General Guidelines; Power Supply; Cleaning And Maintenance - HQ-Power HQPE10001 Manual Del Usuario

3.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.

Do not shake the device. Avoid brute force when installing or operating the device.

Familiarise yourself with the functions of the device before actually using it. Do not allow operation
by unqualified people. Any damage that may occur will most probably be due to unprofessional use
of the device.

Use the original packaging if the device is to be transported.

All modifications of the device are forbidden for safety reasons.

Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, crash, etc. Using the device in an unauthorised way will void the warranty.

Keep this manual for future reference.

Only fill the tank when the device is unplugged from the mains.

Use only bubble liquid without oil or grease. Any non-recommended bubble liquid may damage the
bubble machine.

Fill the tank only with specially designed water-based bubble liquid. Please contact your dealer for
more information.
4.

Power Supply

4.1 Battery
1. Make sure the device is switched off.
2. Loosen the screw on top of the device and take off the cover.
3. Replace the old batteries and/or install two new 1.5 V C/R14-size batteries in accordance with the
polarity markings inside the battery compartment.
4. Replace the cover and tighten the screw.
Warning: Do not puncture batteries or throw them in fire as they may explode. Do not
attempt to recharge non-rechargeable batteries (alkaline). Dispose of batteries in
accordance with local regulations. Keep batteries away from children.
4.2 Adapter
The HQPE10001 bubble machine can also be powered via the included power adapter. Only use the
included power adapter or an exact equivalent.
5. Operation
1. Make sure the device is switched off.
2. Make sure the batteries are installed. If powering the device via the power adapter, make sure it is
not yet plugged in.
3. Place the device on a solid, flat and stable surface. Avoid placing it in direct sunshine and near heat
sources.
4. Pour approximately 140 ml of bubble liquid into the reservoir. Do not overfill the reservoir as bubble
liquid can spill, making the surface slippery.
5. If powering the device via the power adapter, plug it into the device and then into the mains.
6. Switch on the device via the on-off switch. It is advised not to run this device for more than one
hour continuously.
7. Switch off after use and disconnect from the mains. Empty the tank accordingly.
6.

Cleaning and Maintenance

This device does not need any particular maintenance. Occasionally wipe it with a damp cloth. Do not use
harsh chemicals, cleaning solvents or strong detergents.
If the power cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly
qualified persons in order to avoid any hazard.
V. 01 – 06/01/2016
HQPE10001
4 ©Velleman nv