INSERTING
THE DOOR PANELS
Cut-Out
1. Loosen the Top Trim on the freezer and fresh
food doors,
• Using a "I"-20 Torx Driver, loosen the two screws
attaching the Top Trim about 114" (6 mm).
2. Insert the panels.
- Lift the Top Trim up 1/4" (6 mm) and carefully push
the top freezer panel in until it slides into the slot
behind the door handle. Push the filler panel (required
with some door panels) in behind the decorator panel.
Repeat for fresh food panel. If your model has a
dispenser and/or a Convenience
Center, this step
only applies to the top panels
3, Insert the bottom
panels (for models with a
dispenser and/or Convenience Center),
• Carefully push the panel in until it slides into the slot
behind the door handle. Push the filler panel (required
with some door panels) in behind the decorator panel,
4oTighten
the two screws on the Top Trim to
30 in-lbs torque. Do not overtighten.
5. Install the Side Trim. These pieces are tucked inside
the fresh food door handle..
DO NOT remove the protective film on the outside
of the Side Trim until the Side Trim is installed.
• Fit the bottom of the Side Trim under the Bottom Trim
as illustrated
• Hold the Side Trim against the front face of the
decorator panels and fit the Side Trim under the Top
Trim Make sure the Side Trim is fitted correctly and
that you are satisfied with the appearance of all the
parts before pulling the tape liner..
6, Secure the Side Trim.
• Place one hand between the two pieces of tape liner
and hold the Side Trim firmly against the panels and
the side of the door
• Pull the top tape liner up about 3" (80 mm), pressing
the trim with your hand as the adhesive is exposed to
the door. Then pull the bottom tape liner down about
3" (80 mm). Follow the tape with your hand, pressing
the trim adhesive against the door.
• Continue pulling the tape liner loose, alternating
between the top and bottom and pressing the Side
Trim against the door..
7. Remove the protective film from the outside of
the Side Trim.
Tape
Liner
Side
Trim
Side
Trim
tl