Door Alignment - Sears Kenmore 363 Manual De Uso Y Cuidado

LEVELING ROLLERS
The rollers have two purposes:
1. The rollers need to be adjusted so the refrigerator is
firmly positioned on the floor and does not rock back
and forth.
2, The rollers allow you to move the refrigerator away
from the wall for cleaning.
To adjust the rollers:
• Remove the base grille
by pulling it out at the
bottom.
DOOR ALIGNMENT
After leveling, make sure that the doors are even at
the top..
To make the doors even, adjust the fresh food door_ Using
a 3/16" Allen wrench or 5/16" (8 ram) socket wrench
(depending on model), turn the door adjusting screw to
the right to raise the door, to the left to lower ito (A nylon
plug, imbedded in the threads of the pin, prevents the
pin from turning unless a wrench is used.) After one or
two turns of the wrench, open and close the fresh food
door and check the alignment at the top of the doors.
Turn the two front
roller adjusting screws
clockwise to raise
the refrigerator,
counterclockwise to
lower ito Use a 3/8"
socket wrench,
adjustable wrench
or pliers°
. Buitt-ln Style models also
have rear adjustable rollers
so you can align the
refrigerator with your
kitchen cabinets° Use a
5/16" socket wrench to
turn the screws for the
rear rollers--clockwise
to raise the refrigerator,
counter-clockwise to
lower it.
Front Roller
Adjusting
Rear Roller Adjusting Screw
(on Built-In Style models
only) Use this screw if the
refrigerator has one.
Front Roiler
Rear Roller Adjusting
Screw (on Built-In Style
models only)_ Use this
screw if the refrigerator
does not have the screw
pictured above,.
Remove base grille
by opening the doors
and pulling the grille
straight out.,
or
5/16" Socket Wrench
_ Raise