Velleman VTSS6 Manual Del Usuario página 6

 Protect this device from shocks and abuse. Avoid brute force when
operating the device.
 Keep this device away from rain, moisture, splashing and dripping
liquids.
 Familiarise yourself with the functions of the device before actually
using it.
 All modifications of the device are forbidden for safety reasons.
Damage caused by user modifications to the device is not covered
by the warranty.
 Only use the device for its intended purpose. Using the device in
an unauthorised way will void the warranty.
 Damage caused by disregard of certain guidelines in this manual
is not covered by the warranty and the dealer will not accept
responsibility for any ensuing defects or problems.
 Nor Velleman nor its dealers can be held responsible for any
damage (extraordinary, incidental or indirect) – of any nature
(financial, physical...) arising from the possession, use or failure of
this product.
4. How to solder
 File off any dirt, rust or paint on the parts you wish to solder.
 Heat the parts with the soldering iron.
 Apply resin-based solder to the part and melt it with the soldering
iron.
 NOTE: Be sure to apply a solder paste to the part before applying
non resin-based solder.
 Wait for the solder to cool and harden before moving the soldered
part.
 CAUTION: Handle a heated soldering iron with extreme care as
the high temperatures may cause burns.
 The soldering iron may produce smoke at first use due to a dried
out heating element.
 This is normal and should only last for approx. 10 minutes.
 Never file the soldering tip.
 Use a soldering iron stand in order to avoid burns.
 The temperature of the soldering iron will drop if it is used without
the tip.
 Let the soldering iron cool after use.
 The mains cable of this device should not be replaced. Discard the
device if the power cable has been damaged.
V. 03 – 24/11/2014
VTSS6
6 ©Velleman nv