GE PP989 Manual Del Propietario E Instrucciones De Instalación página 23

I NsTAllING The BloWeR PleNum
12
To The CookToP
Slide the plenum, with the blower opening on the
left, into the opening in the bottom of the cooktop .
Push up on the plenum until the stops on the
plenum contact the bottom of the cooktop, and
snap the plenum into place . (You may have to move
the plenum back and forth to work it into place . )
Secure the plenum to the bottom of the cooktop,
on each side, using the four (4) screws provided .
Further secure the plenum to the cooktop, from
the top side, using the two screws (2) provided .
Installation Instructions
INsTAllING The CookToP
Install 2 screws
Install 4 screws
23
I NsTAllING The BloWeR
13
To The PleNum
Orient the blower discharge opening to match the
ductwork in Steps 6 and 7 . Slide the four threaded
studs on the side of the blower housing into the
four holes on the side of the plenum .
NoTe: See Step 14 for installing the transition
duct to the blower . It may be easier to install the
transition duct to the blower before installing the
blower to the plenum .
From the vent opening in the top of the cooktop,
fasten the blower assembly securely to the plenum
with four (4) nuts .
4 Nuts
(7/16≤
socket
required)