SPD PRO TOTAL FIT Manual De Instrucciones página 5

ASSEMBLY INSTRUCTIONS
Unpack the components, check with the components list that none are missing, and
throw away all plastic, cardboard and polystyrene protective packaging from the
equipment. NOTE: Some components may be hidden in the polystyrene.
Steps 1, 3 and 7 will come already assembled for your convenience.
STEP 1
Place the large caps (x2) (component 12) on the main support (component 1).
Assemble the seat (component 7) using components 24, 25, 26 and screws B
(component 16), as seen in the image. After you have done this, for your safety,
immobilise the seat with the adjustment knob (component 22).
STEP 2
Assemble the front frame (component 2) and screw it to the main support using
screws D (component 18). Assemble the back frame (component 3) and secure it with
the adjustment knob (component 22).