Battery Charge; Led And Function - TXED BIKE E-TIMES CITY 4000 DV Instrucciones De Uso

From the initial position 12 o'clock (where the battery and carrier are unlocked), insert the key into the key
slot, press and turn it clockwise to position 6 o'clock (Then the battery is locked with the carrier). On the
contrary, you can unlock it.

Battery charge

If an AC outlet is available within reach of your bike, you can charge your bike directly with the battery still
attached to the bike. The charging port is covered by a plastic cap, with a yellow arrow for notice (Fig 4.3).
Pls open it then you charge the battery directly (Fig 4.4).
Removing the battery is useful for charging in a location where the bicycle may not fit or when no reachable
AC power supply exists at the place where the bike is parked.
Before removing the battery from the bike, you need to unlock as following steps:
* make sure the switch is off (Fig4.5).
* Press the key and turn it anticlockwise from 6 o'clock to 12 o'clock position. (ref. Fig 4.2)
* Remember to take off and care about the key after you withdraw the battery from the carrier!!!
Fig. 4.3 Fig. 4.4 Fig. 4.5

5. LED and Function

5.1 6KM/H (Fig. 5)
The bike can be power-assistance at the speed of 6 km/h when
you keep pressing this button.
After the motor starts working and the bike running, you could
easily pedal and release the button.
(Fig. 5)
5.2 Power display on handlebar panel:
Under normal state, turn on the power supply, the four LED lights will be displayed from low to high power
levels. When all LED lights are bright, this condition indicates that the electricity is full. If the last light has
been flashing, this is a warning, should be charged immediately before riding the battery.
4 LED light on: power is 100%
3 LED light on: power is 70%
2 LED light on: power is 50%
1 LED light on: power is 25%
1 LED light is on and flashing: power will be empty, the battery need to be charged immediately.
37/74