Installing The Transmitter; Installing The Receiver - Perel EDB7 Manual Del Usuario

CAUTION:
Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type.
Batteries (battery pack or batteries installed) shall not be exposed
to excessive heat such as sunshine, fire or the like.
Where the mains plug is used as the disconnect device, the
disconnect device shall remain readily operable.
Do not puncture batteries or throw them in fire as they may
explode. Do not attempt to recharge non-rechargeable batteries
(alkaline). Dispose of batteries in accordance with local
regulations. Keep batteries away from children.
7. Installation
Test the operating range between the receiver and the transmitter.
The operating range is 100 m in the open air, but may be less due
to walls and other obstructions such as PVC or metal frames.

7.1 Installing the Transmitter

1. Carefully open the housing of
the transmitter and use the
back plate as a template.
Mark the drilling holes at the
required height.
2. Drill the holes using a drill
and the appropriate drill bit
(not included).
3. Insert a nylon plug (included)
into each hole.
4. Fix the back plate with the
included screws. Click the
front plate onto the back
plate.
Remark: You can also fix the transmitter using double-sided tape.

7.2 Installing the Receiver

Simply plug the receiver into the mains.
V. 03 – 02/01/2020
EDB7
5 ©Velleman nv