Perel EDB8 Manual Del Usuario página 5

6. Battery
6.1 Transmitter
1. Open the transmitter using a flat-head screwdriver: carefully
push the clips at the bottom and twist very slightly.
2. Install the included CR2032 lithium battery in accordance with
the polarity markings inside the battery compartment.
3. Close the housing.
6.2 Receiver
1. Remove the battery cover.
2. Install two 1.5 V AA batteries in accordance with the polarity
markings inside the battery compartment.
3. Close the housing.
7. Installation
7.1 Preliminary Remarks
 Install the receiver and transmitter within their operating distance.
 Do not install the receiver and transmitter onto or near uPVC or
metal objects, near heat sources or in damp areas.
7.2 Transmitter
1. Drill two holes with a diameter of 6 mm (distance 36 mm) at the
required height. Insert a nylon plug into each hole.
2. Punch the two holes in the back cover.
3. Fix the back cover onto the wall and click the front cover onto
the back cover.
4. You can also stick the transmitter onto the wall with double-
sided tape.
V. 01 – 21/12/2015
Warning: Do not puncture batteries or throw them in
fire as they may explode. Do not attempt to recharge
non-rechargeable batteries (alkaline). Dispose of
batteries in accordance with local regulations. Keep
batteries away from children.
EDB8
5 ©Velleman nv