Safety; General Safety Instructions; Menu System - Husqvarna HMI Manual Del Usuario

General safety instructions

WARNING: Read the warning instructions
that follow before you use the product.
Note: Each product can have different configurations.
Thus, the information on the display can be different
from the illustrations shown in this operator's manual.
Note: The illustrations in this operator's manual show
English text, but the texts on the display will be in the
selected language. Refer to
page 3 .
To operate the menu system
• Push the menu button to open the setup menu.
• To do a selection on the display, push the related
selection button to the left or the right side of the
display.
Note: You cannot touch the symbols on the display
to select them.
• To go back in the menu structure, select the arrow
symbol in the bottom left corner of the display.
For an overview of the menu structure, refer to
overview on page 16 .
Setup menu 1
Language
1
Metric
2
3
1. Select language. Refer to
page 3 .
2. Length unit. Select between metric and imperial
length units.
3. Go back in the menu structure.
4. Light intensity on the display. Select between 3
levels and automatic light.
5. Temperature unit. Select between °C and °F.
6. Regeneration. Refer to
1247 - 001 - 09.07.2019
Display text language on
Menu
Setup Menu 1
Backlight
Auto
Celsius
Regeneration
Display text language on
Regeneration on page 7 .

Safety

• Read this operator's manual together with the
operator's manual for the product.
• You must read and understand the 2 operator's
manuals before you operate the product.

Menu system

Display text language
1
1. Go back in the menu structure.
2. Move up in the list of available selections.
3. Move down in the list of available selections.
4. Select language.
Setup menu 2
1
2
3
4
1. Select to view system information. Refer to
information on page 4 .
5
2. Select to view gearbox and blade information. Refer
to Gearbox and blade information on page 4 .
3. Go back in the menu structure.
6
4. Select to view fault codes. Refer to
codes on page 4 and Fault codes that are not
related to the engine on page 5 .
5. Select to view the service timer menu. Refer to
Service timer menu on page 5 .
6. Calibrate E-track. Refer to
for E-track on page 6 .
English
Danish
German
Spanish
Finnish
French
Dutch
Norwegian
Setup Menu 2
Engine fault
To adjust the center angle
2
3
4
4
5
6
System
3