Troubleshooting; Warning Messages On The Display - Husqvarna HMI Manual Del Usuario

Warning messages on the display

Symbol Text message
"Disengage Blade Clutch before engine can be started."
"Service Needed. See Service Timer Menu."
"Engine Overheated."
"No Blade Water Pressure."
"Machine Stop Pressed: Restore Machine Stop and cycle ignition."
"Machine Stop State Active: Please cycle ignition."
"Crank Error: Please cycle ignition slowly. If problem still exist check
harness and Fault Codes."
"Speed Control Not in Stop Position."
"Regeneration must be performed. Work is no longer allowed due to
high soot load. Engine speed has been limited to 1500 RPM. Recom-
mended fuel level before starting regeneration is at least 50%. Regen-
eration takes 30 minutes."
"Regeneration must be performed. Engine is locked due to high soot
load. Work is no longer allowed. Recommended fuel level before start-
ing regeneration is at least 50%. Regeneration takes 3 hours."
"Engine power has been reduced due to high soot load. Regeneration
must be performed to prevent engine from locking. Recomended fuel
level before starting regeneration is at least 50%. Regeneration takes
30 minutes. Working hours left: 3:00."
"No Machine Type Selected."
"Driving at low idle builds up particles and reduces time between regen-
eration."
"Engine has been turned of due to more than 10 min in low idle. Cycle
ignition to restart the engine."
"Regeneration Could Not Be Activated."
"Regeneration Interrupted."
1247 - 001 - 09.07.2019

Troubleshooting

Related products
Applicable for all products.
Only applicable for
FS5000 D.
Applicable for all products.
Only applicable for prod-
ucts that comply with the
Euro V Emission standard.
9