Troubleshooting - SOPRO COMEG SYMBIOZ Cam Manual De Usuario

10
• Check that the mains socket at the back of the camera is properly connected to the power
supply and that the general switch at the back of the camera is in the operating position
("I").
• Check that the fuses are in good condition (only use the fuses specified on the back panel).
• Check that the sensor is properly connected to the control unit (if not, a colour bar will be
displayed), and that it is filming a workable image.
• Check that the control unit on the camera is correctly connected to the monitor (cable in
good condition, plugs correctly pushed in).
• If the video channel has several components, connect the camera directly to the monitor to
verify that the problem is not with one of the peripherals.
• Check that the monitor is in fact switched on, wired to the correct video input and that the
image settings are at the mid-point position (colour, light and contrast).
• Check the light source, the light cable and the endoscope.
• Check that there is no condensation on the lens.
• Check that the sensor is not aimed at an object that is too bright.
• Check the lens setup.
If there is no image or if the image is not displayed, unplug and re-plug your apparatus or
reset the camera to the factory settings.
• Check that the BRIGHTNESS parameter is not at the maximum or minimum setting.
• Check that the APERTURE used is not too wide or too narrow.
• Check that the camera head is correctly connected to the control unit.
• Check that the light intensity from the light source is not too low or too high.
• Turn off and turn back on the control unit.
If the fault persists and it becomes necessary to return the camera to the after-sales service de-
partment, be sure to ship it in its original packaging after disinfecting it.
Similarly, it is advisable to return the camera in its entirety (control unit, sensor, lens, cables).
Kindly attach to the shipping order an explanation concerning the fault noted.

TROUBLESHOOTING

10.1 THE INDICATOR LIGHT ON THE STANDBY SWITCH [S1]
DOES NOT LIGHT UP ON START-UP
10.2 THE INDICATOR LIGHT ON THE STANDBY BUTTON [S1]
COMES ON BUT NO IMAGE APPEARS ON THE SCREEN
10.3 THE IMAGE IS BLURRED AND WHITE ALL OVER
10.4 THE IMAGE IS EXTREMELY LIGHT OR DARK
- 27 -