Checking Unit Condition; Cutting Grass With A; Trimmer Head - Shindaiwa HomePro T195s Manual Del Propietário

Checking Unit Condition

Never operate the unit with the cutting
attachment shield or other protective
devices removed!
WARNING!
A cutting attachment shield or other
protective device is no guarantee of
protection against thrown objects.
YOU MUST ALWAYS GUARD
AGAINST FLYING DEBRIS!
Cutting Grass
Your Shindaiwa T195s/F195s grass trim-
mer is equipped with a semi-automatic
nylon trimmer head.
Engine Operating Speeds
Operate the unit at full throttle while
cutting grass.
CAUTION!
Do not push the rotating line into trees,
wire fences or any material that could
tangle or break the nylon lines.
CAUTION!
Operation of trimmer without a cut-
ting attachment shield and using
excessive line length can lead to
premature clutch failure.
CAUTION!
Operation at low rpm can lead to
premature clutch failure.
10
Use only authorized Shindaiwa parts
and accessories with your Shindaiwa
trimmer. Do not make modifications to
the unit without the written approval of
Shindaiwa, Inc.
ALWAYS make sure the trimmer head
is properly installed and firmly tightened
before operation.
NEVER use a cracked, warped, or worn
out trimmer head: replace it with a ser-
viceable one.
ALWAYS make sure the trimmer head
fits properly into the appropriate holder.
If a properly installed head vibrates,
replace it with new one and recheck its
operation.
Trimming and Mowing Grass
T195s
Figure 17
Hold the grass trimmer as shown in the above illustration.
The trimmer head should be angled slightly into the area
to be cut. To ensure maximum trimmer-line service life, cut
only with the tip of the trimmer line. Sweep the trimmer head
left to right (T195s), and right to left (F195s) to trim the
grass. During cutting operations, the trimmer head should
be kept horizontal to the ground at all times.
ALWAYS stop the engine immediately
and check for damage if you strike a
foreign object or if the trimmer head
becomes entangled. Do not operate with
broken or damaged equipment.
NEVER allow the engine to run at high
speed without a load. Engine operation
at high speed without a load could dam-
age the engine.
NEVER operate a unit with worn or dam-
aged fasteners or attachment holders.
F195s
Figure 18
Edging
Tilt the handle approximately 100 de-
grees to the right (from horizontal) and
move forward while holding the trimmer
vertical.
Figure 19