Porter Cable PCI2200 Manual De Instrucciones página 20

Then slide the two washers (DD)
on each end of the axle and secure
with cotter pins (FF), bend one side
of cotter pins.
5. Place the generator upright so it is
resting on the wheels and stands.
handle Kit Assembly
1. Install handles on the engine side
of the generator by securing each
bracket (GG) with bolts (II) and nuts
(JJ).
2. Place handle assembly (HH) onto
each bracket (GG)
each with remaining bolts (II) and
nuts (JJ)
3. Tighten the bolts until the assembly
is snug.
ADD ENGINE OIL AND FUEL
CAUTION: The engine IS NOT filled
with oil from the factory. Oil must be
added to the engine before operating or
damage to engine may occur.
Oil Recommendations
SAE 10W-30 is recommended for general
use. Refer to the Viscosity-Ambient
Temperature Chart for recommended
oil within your local area's average
temperature range. NOTE: Synthetic oil
is NOT recommended.
Viscosity-Ambient
Temperature Chart
5W-30
˚F -20 0 20
˚C -28.8-17.7-6.6 4.4 15.5 26.6 37.7
To add oil (Fig. 2)
1. Refer to
Temperature Chart for correct
viscosity.
2. Remove dipstick (L).
3. Slowly add recommended oil,
see specifications for oil capacity.
NOTE: If the oil is added too
quickly, it will overflow and appear
to be full.
and secure
30
10W-30
40 60 80 100
Viscosity-Ambient
See To Check Oil under Maintenance
for instructions.
Add fuel to generator (FIG. 1, 5)
WARNING: Risk of explosion or
fire. Gasoline vapor is highly flammable.
Refuel outdoors preferably or only in
well-ventilated areas. Do not refuel or
check gasoline level while the engine
is running. Do not store, spill or use
gasoline near an open flame, a source
of sparks (such as welding), or near
operating electrical equipment. Do not
smoke when filling fuel tank.
1. Remove fuel cap (D).
2. Add fresh, clean, regular unleaded
gasoline with a minimum of 86
octane to the fuel tank (E). NOTE:
Do not mix oil with gasoline.
WARNING: Never fill fuel tank
completely. Do not
fill above
shoulders on the
debris screen (QQ)
as shown to provide
space for
expansion. Wipe any fuel spillage from
engine and equipment before starting
engine.
3. Replace the fuel cap on the tank.
Turn the cap clockwise until it
stops.
Oxygenated Fuels
Some conventional gasolines are
blended with alcohol or an ether
compound.
collectively referred to as oxygenated
fuels. To meet clean air standards, some
areas use oxygenated fuels to help reduce
emissions.
If you use an oxygenated fuel, be sure it
is unleaded and meets the 86 minimum
octane rating requirements. Before
using an oxygenated fuel, try to confirm
the fuel's contents. Some areas require
this information to be posted on the
pump.
Ethanol (ethyl or grain alcohol) 10%
by volume. You may use gasoline
containing up to 10% ethanol by volume.
Gasoline containing ethanol may be
marketed under the name gasohol.
20- ENG
the
QQ
fuel
These gasolines
5
are