Makita LS1018 Manual De Instrucciones página 10

1
010241
To remove the blade, use the socket wrench to loosen
the hex bolt holding the center cover by turning it
counterclockwise. Raise the blade guard and center
cover.
4
1
2 3
010242
Press the shaft lock to lock the spindle and use the
socket wrench to loosen the hex bolt clockwise. Then
remove the hex bolt, outer flange and blade.
NOTE:
When inner flange is removed mistakenly, be sure
•
to install it on the spindle with its protrusion facing
the spindle.
2
1
3
010244
1 2 4
3
001786
To install the blade, mount it carefully onto the spindle,
making sure that the direction of the arrow on the surface
of the blade matches the direction of the arrow on the
1. Socket wrench
2
2. Blade case
3. Center cover
3
4. Hex bolt
5. Blade guard
5
4
1. Blade case
2. Socket wrench
5
3. Hex bolt
4. Arrow
5. Shaft lock
1. Blade case
4
2. Arrow
3. Arrow
4. Saw blade
5 1. Hex bolt
2. Outer flange
3. Saw blade
4. Inner flange
5. Spindle
blade case.
Install the outer flange and hex bolt, and then use the
socket wrench to tighten the hex bolt (left-handed)
securely counterclockwise while pressing the shaft lock.
1
010562
Return the blade guard and center cover to its original
position. Then tighten the hex bolt clockwise to secure
the center cover. Release the handle from the raised
position by pulling the stopper pin. Lower the handle to
make sure that the blade guard moves properly. Make
sure shaft lock has released spindle before making cut.
Dust bag (accessory)
1
2
3
010245
The use of the dust bag makes cutting operations clean
and dust collection easy. To attach the dust bag, fit it onto
the dust nozzle.
When the dust bag is about half full, remove the dust bag
from the tool and pull the fastener out. Empty the dust
bag of its contents, tapping it lightly so as to remove
particles adhering to the insides which might hamper
further collection.
NOTE:
If you connect a vacuum cleaner to your saw, more
efficient and cleaner operations can be performed.
Securing workpiece
WARNING:
It is extremely important to always secure the
•
workpiece properly and tightly with the vise. Failure
to do so can cause the tool to be damaged and/or
the workpiece to be destroyed. PERSONAL
INJURY MAY ALSO RESULT. Also, after a cutting
operation, DO NOT raise the blade until the blade
has come to a complete stop.
10
1. Socket wrench
2
2. Blade case
3. Center cover
3
4. Hex bolt
5. Blade guard
5
4
1. Dust nozzle
2. Dust bag
3. Fastener