JB Systems DYNABARREL Manual De Instrucciones página 8

ENGLISH
 Press the [MENU] button for about 2 seconds to store the setting and to return to running mode.
Show Mode
Used to choose the Show mode when used in standalone or master/slave mode.
 Press the MENU button until "ShMd" is showing on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to select one of the available shows. Show 00 is a mixed random show.
 Once the right mode is selected, press the [ENTER] button to confirm.
 Press the [MENU] button for about 2 seconds to store the setting and to return to running mode.
Sound Mode
Used to activate or to deactivate the sound mode to trigger the shows.
 Press the [MENU] button until
 Press the [ENTER] button to select.
 Use the [DOWN & UP] buttons to select one of the available modes:

(sound mode ON)  the shows are triggered by the internal microphone.

(sound mode OFF)  the shows runs at slow speed.
 Once the right mode is selected, press the [ENTER] button to confirm.
 Press the [MENU] button for about 2 seconds to store the setting and to return to running mode.
Dimmer Speed
Allows you to select a fast instant dimming reaction or a slower smoot dimming reaction (like when
you dim an halogen lamp)
 FAST: dimming will be instantly and reactive.
 SMOOTH: "halogen" reactivity simulation activated
 Press the [MENU] button until
 Press the [ENTER] button, the display starts blinking.
 Use [DOWN] and [UP] button to select
 Once the right mode is shown on the display, press the ENTER button to select it.
 Press the [MENU] button for about 2 seconds to store the setting and to return to running mode.
Blackout Mode
Blackout mode: when no DMX-signal is detected, the unit goes in blackout.
No blackout mode: when no DMX-signal is detected, the unit automatically switches to master mode.
ALWAYS set to "No Blackout" when the unit is used in standalone or master (master/slave) mode!!!
 Press the [MENU] button until
 Press the [ENTER] button.
 Use the [DOWN & UP] buttons to select
 Once the mode is selected, press the [ENTER] button to confirm.
 Press the [MENU] button for about 2 seconds to store the setting and to return to running mode.
Led Display
Display on: display is always on.
Display off: display is off when not used.
 Press the [MENU] button until the display shows
 Press the [ENTER] button.
 Use the [DOWN & UP] buttons to select
 Once the mode is selected, press the [ENTER] button to confirm.
 Press the [MENU] button for about 2 seconds to store the setting and to return to running mode.
JB SYSTEMS
®
is shown on the display.
is shown on the display.
or .
is shown on the display.
(blackout) or
.
(display always on) or
6/54
USER MANUAL
(no blackout).
(display off when not used).
DYNABARREL