BLUETOOTH®
[PIN CODE EDIT]
Changes the PIN code (up to 6 digits).
(0000)
1 Perform the following operation to select a number.
KD-X362BT: Turn the volume knob
KD-X361BT: Press VOL +/–
2 Press S / T to move the entry position.
Repeat steps 1 and 2 until you finish entering the PIN code.
3 Press the following to confirm.
KD-X362BT: Volume knob
KD-X361BT: * ENTER
[RECONNECT]
[ON]: The unit is automatically reconnect when the last connected
Bluetooth device is within the connectable range. ; [OFF]: Cancels.
[AUTO PAIRING]
[ON]: The unit is automatically paired with the supported Bluetooth
device (iPhone/iPod touch) when it is connected through USB input
terminal. Depending on the operating system of the connected device, this
function may not work. ; [OFF]: Cancels.
[INITIALIZE]
[YES]: Initializes all the Bluetooth settings (including stored pairing,
phonebook, and etc.). ; [NO]: Cancels.
[INFORMATION]
[MY BT NAME]: Displays the name of your receiver ("KD-X3
[MY ADDRESS]: Shows address of this unit.
Bluetooth compatibility check mode
You can check the connectivity of the supported profile between the
Bluetooth device and the unit.
• Make sure there is no Bluetooth device paired.
1
Press and hold
.
"BLUETOOTH"
"CHECK MODE" appears. "SEARCH NOW USING
PHONE"
"PIN IS 0000" scrolls on the display.
2
Search and select the name of your receiver ("KD-X3
Bluetooth device within 3 minutes.
3
Perform (A), (B) or (C) depending on what appears on the display.
(A) "PAIRING"
passkey appears on the unit and Bluetooth device, then operate the
Bluetooth device to confirm the passkey.
(B) "PAIRING"
(C) "PAIRING": Operate the Bluetooth device to confirm pairing.
After pairing is done successfully, "PAIRING OK"
and Bluetooth compatibility check starts.
If "CONNECT NOW USING PHONE" appears, operate the Bluetooth device to
allow phonebook access to continue.
"TESTING" flashes on the display.
The connectivity result flashes on the display.
"PAIRING OK" and/or "HANDS-FREE OK"*1 and/or "AUD.STREAM OK"*2 and/
or "PBAP OK"*3: Compatible
*1 Compatible with Hands-Free Profile (HFP)
*2 Compatible with Advanced Audio Distribution Profile (A2DP)
*3 Compatible with Phonebook Access profile (PBAP)
BT"). ;
After 30 seconds, "PAIRING DELETED" appears to indicate that pairing has
been deleted, and the unit exits check mode.
• To cancel, press and hold source button to turn off the power, then turn
on the power again.
BT") on the
"XXXXXX" (6-digit passkey): Ensure that the same
"PIN IS 0000": Enter "0000" on the Bluetooth device.
"Device Name" appears
17
ENGLISH