PNI SAFEHOUSE HS550 Manual De Usuario página 14

EN
- To delete all the serial numbers, press
3.4 Wireless Sensors
Pairing a New Sensor
- Select "Main Menu->Parts->Detector->Add".
- Use to scroll to
- Use to scroll to
You must assign a Zone Type to each zone(sensor), which defines the way in which
the system responds to faults in that zone.
"Stay Arm Active" usually assigned to sensors or contacts on entry and exit doors,
exterior doors and windows, perimeter. Active when armed in AWAY or STAY mode.
"Out Arm Active" usually assigned to a interior area (i.e.: foyer, lobby,or room).
Bypassed automatically when armed in STAY mode.
"24 Hours Active" usually assigned to a zone containing an Emergency Button,
Smoke Sensor, CO, Water Leakage and Gas Sensors.
To used as doorbell, select "Doorbell".
To disable the zone, select "Close".
- Use to scroll to , then use digits keypad to enter the Zone Number (0-89 are
available). The Zone Number should be unique.
- Press ,"Synchronizing" is displayed, the system goes into the sniffer mode and
count down the pairing time remaining .
- Active wireless sensor to send a transmission signal to the panel.
- As the serial number of wireless sensor is added to panel, "Leaning OK"will be
displayed.
The system will display"Device code has been learned" if serial number of wireless
sensor have been learned, and the Zone Name/Mode/Number will be refreshed.
Edit/Delete
- Select "Main Menu->Parts->Detector->Edit".
- Use the
- To edit the Name/Mode/Number of displayed zone, press
- To delete the selected serial number, press
Delete All
- Select "Main Menu->Parts->Detector->Delete All".
- A total number of serial numbers learned is displayed.
- To delete all the serial numbers, press
3.5 RFID Tags
Pairing a New RFID Tag
- Select "Main Menu->Parts->RFID->Add".
, then use
, then use
buttons to scroll to the serial number be edited.
to scroll to the desired Zone Name.
to scroll to the desired Zone Mode(Type).
.
14
.