lidl KH 1151 Instrucciones De Uso página 30

2. Step 1: Remove the pins of the connector: Pull out the linch pin.
Step 2: Remove the pin.
1
2
DANGER :
Damaged cables lead to short-circuits. In such cases, touching the fan could
be life-threatening!
During the following insertion do not damage the bolts in the extension
rods 2 and the cable connection piece!
3. Loosen the cover plate e from the covering 1, whereby you press the
individual spring balls through the covering 1 and at the same time pull
the cover plate e away from the covering 1. Lay the cover plate to the
side for later steps in the assembly.
4. Slide the cover 3 and covering 1 as shown in the diagramme over
the extension rod 2.
5. Pull the cable of the motor housing 0 through the extension rod 2.
6. Install the bolts of the connection piece.
7. Insert the safety splint.
8. First tighten both screws evenly and at the same time until hand-tight,
Should you choose the short extension rod 2, proceed in the same way.
9. Slide the cover 3 downwards, so that the connecting piece is concealed.
10. Guide the securing rod through the upper openings of the extension
1
3
- 28 -
then screw them in tightly with the screwdriver.
Note:
7
6
8
rod 2 and align it centrally.
Push the support upwards over the bolts, thereby ensuring that the safety
screw fits into the appropriate recess. Screw the safety screw into the
thread of the extension rod 2.
5