Replacing The Fuse - Minipa MT-1400 Manual De Instrucciones

C. Replacing the Fuse
Warning
To avoid electrical shock or arc blast, or personal injury or damage
to the Meter, use specified fuses ONLY in accordance with the fol-
lowing procedure.
To replace the Meter fuse, follow the below procedure and refer to Figure 8:
1. Turn off the Meter and remove all connections from input terminals.
2. Remove the screw from bottom case, and separate the bottom case
from the top case.
3. Remove the fuse by gently prying one end loose, and then take out the
fuse from its bracket.
4. Install ONLY replacement fuses with the identical type and specification
as follows and make sure the fuse is fixed firmly in the bracket. Fuse:
0.3A, 250V, fast type, 5x20mm.
5. Rejoin the bottom case and the top case, and reinstall the screw.
Replacement of the fuses is seldom required. Burning of a fuse always
results from improper operation.
17