Publicidad
EN
Problem
The appliance
produces no steam
or irregular steam.
Water droplets
drip from the
steamer head
or the appliance
produces a
croaking sound.
An excessive
amount of water
drips out of the
steamer head
when the appliance
is heating up.
Water leaks out
from the steamer
base.
A few water
droplets come out
when the water
tank is detached.
Possible cause
The steamer has not
heated up sufficiently.
Steam has condensed
in the hose.
The water level is
below the MIN level
indication or the
tank is not inserted
properly.
Too much scale
has built up in the
appliance.
You have left the
steamer head and/or
the steam supply hose
in horizontal position
for a long time.
When the hose
forms a U-shape,
condensation in the
hose cannot flow back
into the water tank.
The water in the
appliance is dirty or
has been left inside
the appliance for a
long time.
You have not closed
the water tank cap
or easy rinse knob
securely.
The water tank is not
inserted properly.
This is part of the
water inlet design.
Solution
Let the appliance heat up for
approximately 45 seconds. Use
for faster heat up (GC536 only).
Lift the steamer head to
straighten the hose vertically.
This allows any condensation
to flow back.
Refill the water tank and insert
it properly until you hear a
"click" sound.
Perform easy rinse process.
Refer to
section.
Lift the steamer head to
straighten the hose vertically.
This allows any condensation
to flow back.
Lift the steamer head to
straighten the hose vertically.
This allows any condensation
to flow back.
Perform easy rinse process.
Refer to
section.
Close the water tank cap and
easy rinse knob securely.
Insert the tank properly until
you hear a "click" sound.
This is normal.
25
Publicidad
