cecotec CONGA 1490 Manual De Instrucciones página 42

ENGLISH
It is suggested to empty the dust tank after each use.
Wash the primary filter each 15-30 days to lengthen their lifespan.
Dry completely the filters before placing them back in their position.
Do not expose the filters to direct sunlight.
The maximum service life of the primary and high-efficiency filter is 6 months.
1. Holding from the bottom of the dust tank, press the release button to take out the dust tank.
Fig. 13
2. Open the dust tank cover.
Fig. 14
3. Take the primary and high-efficiency filter out.
Fig. 15
4. Open dust tank and empty it.
Fig. 16
8. Take the primary andHigh-efficiency filter out.
Fig. 17
Empty the dust tank.
Fig. 18
5. Wash the dust tank and the primary filter using water.
Clean the high-efficiency filter with a brush, avoid washing it under water.
Fig. 19
6. Install the primary filter and the high-efficiency filter into dust tank.
Cleaning sensors and wheels
Use a soft damp cloth to clean wheels and sensors.
Fig. 20
Clean the charging terminals
Use a soft damp cloth to clean the charging terminals on the robot and on the charging base.
Use a dry cloth to wipe the charging terminals if the connection is poor.
Fig. 21
Cleaning main brush kit
Remove the main brush kit from the product's main body, separate the cover from the brush
and clean them separately.
The brush can be washed in soap and water.
Fig. 22
Warning: Do not introduce the main brush back in its place unless it is completely dry.
Battery removal and replacement
Remove the screws on the battery cover with a screw driver.
42