Cleaning And Maintenance - cecotec CONGA 1490 Manual De Instrucciones

ENGLISH
Random mode
The robot will start cleaning in Random mode.
Twice mode
The robot will carry out a whole cleaning cycle following the next pattern: Gyro mode, Edge
mode, Gyro mode and Edge mode again. When the cycle is completed, it will return to the
charging base with its smart technology.
Scrubbing mode
Choose the intensity of the scrubbing on the water intensity menu. With this mode, the robot
will carry out a cleaning cycle in Gyro mode and in Edge mode, moving forward 2 metres and
then backwards 1 metre consecutively, simulating a real scrubbing movement. It will return to
the charging base if necessary to finish cleaning, and finally will return to the charging base
when it runs out of battery. You can select the desired water intensity level: high, medium or
low.
Do not use the mop outdoors.
Remove the carpets before operating the robot under this mode.
During operation, control the water level on the Wet&dry tank. Fill the tank when it is empty.
Remove the Wet & dry tank and the mop from the robot before charging it.
Note: In order to ensure perfect scrubbing, moisten the mop before starting scrubbing.
Gyro mode
When this mode is activated, the robot will carry out a whole cleaning cycle in Gyro mode and
then in Edge mode. Once it has finished, it will automatically return to the charging base. If the
robot has not started cleaning from the charging base, it will return to the starting point.
Note: If the room being cleaned is smaller than 10 m2, the robot will carry out the same cycle
twice.
Back home mode
This mode can be selected at any point of any cleaning cycle. Once it is activated, it will
automatically return to the charging base. If the robot has run out of battery, it will return to
the charging base with the LED indicator in red, if it returns with battery, the LED light will be
lit in blue.
Manual mode
Use the direction buttons to take the robot to the specific points where you want it to clean.

5. CLEANING AND MAINTENANCE

Cleaning the side brushes
Make sure the side brushes are in good conditions.
If the bristles are deformed, introduce the side brush into hot water.
Clean them regularly in order to keep them in good conditions.
Cleaning Wet&Dry and filters
41