Overheating Protection; Frost Protection Function; Topple Over Protection - Silvercrest SWW 1500 A1 Instrucciones De Uso

Handling and operation
♦ Whilst the preset time is blinking in the display
+/-
hours. As soon as the switch on time lights up continuously in the display
the setting is adopted and the device switches on, after the time has expired,
to the high heating output (HIGH).
♦ Press the button AUTO ON
the switch on time. In the display

Overheating protection

With excessive temperature rise the device automatically switches off and in the
display
Should this occur...
♦ Switch the device off at the main switch POWER
plug from the wall socket. Allow the device to cool down for a few minutes
♦ After the cause of the overheating has been removed, i.e. a covered heating
element, the device can be switched on again.

Frost protection function

The device is equipped with a frost protection function which automatically switches
to the high heat output (HIGH) as soon as the room temperature falls below 7°C.
When the room temperature has reached 10°C the appliance automatically
switches back to standby mode.
♦ Activate the main switch POWER
into standby operation. In the display
function
The device now switches on if the room temperature drops below 7°C.

Topple over protection

The device is equipped with topple over protection which automatically switches
the heating element
sounds for 1 minute.
SWW 1500 A1
and/or to set the desired switch on time between 1 hour and 24
4 13
appears .
blinks.
9 off if the device topples over. In addition a warning tone
press one of the buttons
and/or again if you want to deactivate
2 11
the indicator AUTO ON
and pull the mains power
6
6 to switch the device on and to shift
the symbol for the frost protection
goes out.
GB
MT
67