Connection With The Web Interface; Ip Address; Login; Calling Up The Web Interface In Access Point Mode - Kemper AirWatch Manual De Uso

KEMPER AirWatch operating instructions - EN

2.11 Connection with the web interface

To be able to use the AirWatch functions, you must connect the AirWatch with the
web interface. To do this, the IP address of the AirWatch must be entered in any
browser. As a rule, it is also necessary that AirWatch and the terminal device are in
the same network.

2.11.1 IP address

For convenient access to AirWatch, it is recommended that you allocate a manual IP
address for WLAN or cabled connection (for selecting a manual IP address, please
contact a network administrator).
For access to the web interface, only the allocated manual IP address must be
entered in your browser and opened by confirming.

2.11.2 Login

When calling up the web interface, you are prompted to enter a user name and
password combination. In the as delivered state, these are:
User name: "AirWatch"
Password: "AirWatch"
You can set a different password and/or user name in the settings. This is highly
recommended!

2.11.3 Calling up the web interface in access point mode

If the AirWatch network function is configured as access point mode, a call with
AirWatch via the access point suffices. To do this, go to your terminal device WLAN
settings and select the access point.
Part no.: 150 2608 - 55 - Rev.: 00
Issue: 03/2017
All rights over changes without prior notice and errors reserved.