Technical Properties; Sensor System; Specification; Wireless System - Kemper AirWatch Manual De Uso

KEMPER AirWatch operating instructions - EN

9 Technical properties

9.1 Sensor system

− Method: Optical, laser-based
− Measuring range: 17µm – 0.1µm

9.2 Specification

− Current drain: < 15W
− Voltage: 110V – 240V, 50/60Hz
You must check the level in the dust collection container at regular intervals and
change it as necessary.
The time until the dust collection container must be exchanged depends on the type
and quantity of the attacking dust. The operator must check the level by hand at
regular intervals to avoid the dust collection container becoming overfull.
The dust collection container must always be exchanged in good time to avoid
contamination of the surroundings!
The filter system should be switched off when checking the fill level. Activate the
On/Off switch and wait until the light ring on the on/off switch completely stops
blinking. Then pull out the mains plug.

9.3 Wireless system

− System: 2.4GHz ISM – KEMPER wireless system

9.4 Communication

− WLAN module
Part no.: 150 2608 - 72 - Rev.: 00
Issue: 03/2017
All rights over changes without prior notice and errors reserved.