Recommended Use; Technical Specifications - Fox F28-186A Manual De Instrucciones

EXTENSION CABLES
Only use three conductors extension cables, with a plug with two plugs and a earthing
contact and sockets with two holes and a earth corresponding to the plug of the tool. When
using an electric tool at a remarkable distance from the power supply, use an extension cable
with sufficient dimensions to transport the current which the tool needs. If the extension cable
has not the sufficient dimensions a voltage drop can occur, thus causing an overheating and
a voltage loss. You can only use extension cables which are in compliance with CE
standards.
Extension cable length: up to 15 m
Cable dimensions: 3 x 2,5 mm²
Before using any kind of extension cable, check that it has not bare wires and that the
insulation is not cut or worn. Repair and change immediately it if it is damaged or worn.
WARNING:
Extension cables must be arranged away from the working area in order that they do not get in
touch with the workpieces, the tool or other parts of the machine, thus creating possible risks.
WARNING:
KEEP THE TOOLS AND THE EQUIPMENT AT A SAFE DISTANCE FROM CHILDREN
This bandsaw has been manufactured for cross cutting and trimming of plastics, wood.
Maximum cutting height is 120 mm with the workbench at 0°.
The workbench can be inclined up to 45° to angle cut.
Engine power:
Voltage and frequency:
Blade rotational speed:
Blade's length:
Blade's width:
Gooseneck:
Maximum cutting height:
Workbench inclination capacity:
Workbench dimensions:
Weight:

RECOMMENDED USE

TECHNICAL SPECIFICATIONS

420 W
230 V – 50 Hz
660/960 m/min
1790 mm
6 - 13 mm
244 mm
120 mm
from 0° to 45°
290x290 mm
30 kg
29