Fermax Duox VEO XS Manual De Instalador página 32

A different call tone is produced, confi rming the monitor's programming and the camera's
image is still viewed.
address is programmed it is indicated via a fi xed red light.
b) From the Monitor.
Monitors can be programmed on the screen menu.
Program the call number: Press on the screen and access the screen to program the
residence's number (numbers from right to left).
Each time the + is pressed the number increases (starting with 1) and the arrow is used
for moving the cursor. A white cursor indicates where the digit will be entered. Program the
corresponding number and accept with . Once the monitor's address is programmed it
is indicated via a fi xed red light.
c) From the doorbell.
Via the entrance doorbell, the monitor address can also be programmed.
For this type of operation, the monitor must not be previously programmed.
Long press the doorbell for 5 seconds, you will hear a confi rmation beep for entering into
the monitor's program.
The monitor will automatically connect with the entry panel, activating the camera. Enter
the calling code for this monitor from the panel. Depending on the type of panel installed:
- by pressing the corresponding button or entering the code + bell.
A different call tone is produced, confi rming the monitor's programming and the camera's
image is still viewed.
address is programmed it is indicated via a fi xed red light.
Notes:
- The time between hearing the confi rmation beep for entering the monitor programming
option until the call is made from the panel to program the address must be less than
2 and half minutes.
- Programming is always done from the panel activated as the master panel.
12
DUOX VEO XS MONITOR
After a few seconds the monitor returns to standby.
After a few seconds the monitor returns to standby.
Once the monitor's
Once the monitor's