Fermax Duox VEO XS Manual De Instalador página 40

Notes:
- If there are various telephones in the same home, the audio will only come from the fi rst
one picked-up, leaving the remaining monitors/phones in standby. If you try hanging one
of them up, a busy signal will sound.
- If communication is not established with the entry panel, the monitor will automatically
turn off after 30 seconds.
2. OPERATION: MANUAL MONITOR ACTIVATION (AUTO-START)
With the monitor on standby, press and hold the button
on manually.
Communication is established with the "0" panel of the block corresponding to the monitor
(if there is one). If there is no monitor, the auto-start is activated on panel 1 of the same
block, and if there is none, communication is established with the confi gured panel, like
0 of the General Entrance.
Once the communication is established with a panel, you can change it via the displayed
contextual menu (pressing the corresponding button):
- button 0: Panel 0 Camera of the block where the monitor is installed.
- button 1: Panel 1 Camera of the block where the monitor is installed.
- button G: Panel 0 camera of the General Entrance.
Notes:
- Auto-start can only be done with the indicated panels. If you can not perform the auto-start,
ask your installer. Upon unsuccessfully completing the connection attempts with each
of the three possible panels, the monitor will issue an error tone and return to standby.
- After completing any communication with a panel, for the following 15 seconds if you
re-press the auto-start button it will connect with this panel.
0
G
20
DUOX VEO XS MONITOR
(camera) to switch the monitor
1
Panel ID