Playback; Playback I (Either Tape I Or Tape Ii) - Teac W-890RMKII Manual Del Usuario

Playback I (either TAPE I or TAPE II)

1
Switch on the POWER.
Load a pre-recorded tape into the TAPE I or II deck.
2
Press the EJECT key (L) to open the cassette compartment.
Insert the cassette tape with its open edge facing down, the
desired side facing you. Then, close the cassette compartment by
pushing on its front part.
This cassette deck can play back normal (Type I), high position
(Type II) and metal (Type IV) tapes.
For the sake of simplicity, we refer to the tape side facing you as
Side "A" and to the tape side facing away as Side "B". When you
insert a cassette with Sides "A" and "B" reversed, Side "A" should
read Side "B" and Side "B" should read Side "A".
12

Playback

3
4
Side "A" facing you
Select a reverse mode setting using the REV MODE switch.
You have a choice of three settings:
7: One way mode
Set the switch to this position to playback only one side.
j: Two way mode
Set the switch to this position to play back both sides
of the tape in one session. When playback reaches the
end of side "A", the playback direction is automatically
reversed, and playback continues on side "B".
p: Repeat mode
Set the switch to this position. Both sides of the tape are
played back as many as 5 times.
If a tape is in both the TAPE I and TAPE II compartments,
the TAPE I and TAPE II decks continuously play the tapes.
Press the PLAY (h or y) key.
Pressing the y key starts playback from side "A".
Pressing the h key starts playback from side "B".