Operation - RIDGID R250AF18 Manual Del Operador

Clavadora de acabado angular
Ocultar thumbs Ver también para R250AF18:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION

WARNING:
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of
a second is sufficient to inflict severe injury.
WARNING:
Always wear safety goggles or safety glasses
with side shields when operating tools. Failure
to do so could result in objects being thrown into
your eyes resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories
not recommended by the manufacturer of this
tool. The use of attachments or accessories not
recommended can result in serious personal
injury.
APPLICATIONS
You may use this tool for the purposes listed below:
 Finish and Trim (Interior and exterior)
 Door & Window Casing
 Door Jambs
 Baseboard
 Crown Molding
 Cabinetry
 Cap and Shoe Molding
 Molding
 Staircases
 Door and Window Trim
 Chair Rail
 Brickmold
 Hardwood Flooring
 Paneling
 Furniture
BATTERY PROTECTION FEATURES
RIDGID 18 V lithium-ion batteries are designed with features
that protect the lithium-ion cells and maximize battery life.
Under some operating conditions, these built-in features
may cause the battery and the tool it is powering to act
differently from nickel-cadmium batteries.
During some applications, the battery electronics may
signal the battery to shut down, and cause the tool to stop
running.
NOTE: To prevent further shut down of the battery, avoid
forcing the tool.
If releasing the trigger and removing and reinstalling the
battery pack does not reset the battery and tool, the battery
pack is depleted. If depleted, the battery pack will begin
charging when placed on the lithium-ion charger.
For complete charging instructions, refer to the operator's
manual for the R840091 charger. For battery pack instruc-
tions, see the manual for the R840084 lithium-ion battery
pack.
TO INSTALL BATTERY PACk
See Figure 2, page 14.
 Place battery pack in the tool. Align raised rib on battery
pack with the groove inside the tool.
 Make sure the latch on the back of the battery pack snaps
in place and battery pack is secured in the tool before
beginning operation.
CAUTION:
When placing battery pack in the tool, be sure
raised rib on battery pack aligns with the bottom of
the tool and latches into place properly. Improper
installation of the battery pack can cause damage
to internal components.
TO REMOVE BATTERY PACk
See Figure 2, page 14.
 Locate latch on the back of battery pack and depress to
release battery pack from the tool.
 The battery pack will disconnect in direction to be re-
moved when latch is depressed.
WARNING:
Battery tools are always in operating condition.
Therefore, switch should always be locked when
not in use or carrying at your side.
9 - English

Publicidad

Tabla de contenido
loading

Tabla de contenido