Operation - RIDGID R250AF18 Manual Del Operador

OPERATION

WARNING:
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always remove battery pack from the tool when
you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery
pack will prevent accidental starting that could
cause serious personal injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes, resulting in possible serious injury.
APPLICATIONS
You may use this tool for the purposes listed below:
 Finish and Trim (Interior and exterior)
 Door & Window Casing
 Door Jambs
 Baseboard
 Crown Molding
 Cabinetry
 Cap and Shoe Molding
 Molding
 Staircases
 Door and Window Trim
 Chair Rail
 Brickmold
 Hardwood Flooring
 Paneling
 Furniture
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 13.
 To install, place battery pack in the tool. Align raised rib
on battery pack with the groove inside the tool.
 Make sure the latch on the back of the battery pack snaps
in place and battery pack is secured in the tool before
beginning operation.
NOTICE:
When placing battery pack in the tool, be sure
raised rib on battery pack aligns with the bottom of
the tool and latches into place properly. Improper
installation of the battery pack can cause damage
to internal components.
 To remove, locate latch on the back of battery pack and
depress to release battery pack from the tool.
 The battery pack will disconnect in direction to be re-
moved when latch is depressed.
WARNING:
Battery tools are always in operating condition.
Therefore, switch should always be locked when
not in use or carrying at your side.
NO-MAR PAD
See Figure 3, page 13.
The no-mar pad attached to the nose of the tool helps pre-
vent marring and denting when working with softer woods.
WARNING:
Remove the battery pack from the tool before
removing or replacing the no-mar pad. Failure to
do so could result in serious personal injury.
The pad can be removed by pulling it down and away from
the nose. To replace the pad, fit it into place over the nose
and push up at the back to reseat.
9 - English