Osd Message - NEC LCD19WV-BK-R Manual Del Usuario

Controls
Main Main
Menu Menu
Item Icon
OSD
Setup
Language
Information
Reset
Exit

OSD Message

Auto Confi g Please Wait: If User presses Hot-Key "Auto," a message will appear, and the monitor
will do the auto confi guration function.
Input Not Supported: this message will appear when the H sync frequency, V sync frequency or
Resolution is out of the monitor's support range.
Cable Not Connected: this message will appear when the video cable is not connected.
No signal: this message will appear when the video cable is connected but there is no active signal
input. After 5 seconds the monitor will enter Power-Saving mode. This message is located in the position
setting "OSD Setup."
OSD Locked: When the OSD is locked, hold down the "Menu" key and press the "Power" key once to
turn on the monitor. The OSD will be locked, and this message will appear. When the OSD is locked,
only "Power" key function is still working, and if any other key is pressed this message will remain.
When the OSD is locked, hold down the "Menu" key and press the "Power" key once to turn on the
monitor. The OSD will be unlocked and does not show the message. This message location is in the
position setting "OSD Setup" item.
DDCCI Disable/Enable: When DDCCI enable, press "Auto" key. After 5 seconds the monitor will
show the "DDCCI Disable" message. When DDCCI disable, press "Auto" key. After 5 seconds the
monitor will show the "DDCCI Enable" message. This message is located in the position setting in
"OSD Setup" item.
–continued
Sub Sub
Menu Menu
Item Icon
H.Position
V.Position
OSD
Timeout
N/A
Language
N/A
Information
N/A
Yes
No N/A
N/A N/A
Description
Adjust the Horizontal position of the OSD.
Adjust the Vertical position of the OSD.
Adjust the OSD timeout.
Set OSD language.
Show the resolution, H/V frequency, Serial
No., DDC/CI Enable/Disable and input
port of current input timing.
Clear each old status of Auto-confi guration.
Do not execute reset, return to main menu.
Exit OSD
9